Stepping on the throttle of a high-pressure cleaner
Stepping on the throttle of a high pressure cleaning car is a piece of cake for some experienced high pressure cleaning car drivers. But for some novice drivers, it is very difficult. Specially invited experienced high-pressure cleaning truck drivers, mainly to explain the precautions for stepping on the high pressure cleaning car throttle? All in all, a word: gently step on the lift, linear acceleration, soft and gentle, should not be too haste, toe kung fu, can not suddenly shake. The majority of high pressure cleaning vehicle driver friends, as long as you remember these key phrases, I believe that your high pressure cleaning car will reach the maximum service life, and will reduce fuel consumption, and thus achieve the purpose of saving expenses.
The fourdrinier Paper Making Machine is mainly used for making top grade corrugated base paper, test liner paper,medium paper, high quality light-weight paper (culture paper, newsprint, light weight specialty paper). This kind of peper machine needs to chosse papermaking type, dewatering structure of press section, arrangement of dryer cylinder group, sizing and finishing equipment according to different paper grades and operating speed requirements.
Paper Machine,Paper Product Making Machinery,Liner Board Paper Machine,Test Liner Paper Machine Dandong Tianshin Automatization Technology Co.,Ltd , https://www.ctpmmachine.com
1. When the engine of the high-pressure cleaning vehicle is started, the accelerator pedal of the high-pressure cleaning vehicle cannot be stepped to the end, and it is easier to be slightly higher than the idle throttle. When the high-pressure cleaning vehicle starts, refueling should be done properly before the clutch linkage point, and the accelerator opening degree is preferably medium and small. Relaxation clutches must be in close cooperation with the accelerator pedal.
2, experienced high pressure cleaning vehicle driver should shift the gear should be added empty oil, step on the clutch and step on the accelerator pedal to coordinate with. When you arrive at your destination, when you park your car, you must loosen the gas pedal before you turn off the engine. Don't bang the throttle.
3. When driving a high-pressure cleaning vehicle, when the driver's friends step on the accelerator, he should place the right heel on the floor of the cab, and use the right sole to gently step on the accelerator board to operate. At the same time, attention should be paid to the use of an ankle flexion, stepping on or relaxing, and when the accelerator pedal is depressed, the force should be gentle so that the light pedal can be lifted.
4. The throttle and brake of high-pressure vehicle are all the most critical issues in vehicle control. The throttle of high-pressure cleaner engine is generally controlled by the pedal. It is also called the accelerator pedal. It is the device that controls the fuel supply of the engine.
5. When the high-pressure cleaning vehicle is in the middle of driving, the driver's friends should increase or decrease the throttle according to the road conditions and actual needs, and select the appropriate gear, so that the engine runs at medium speed and large throttle for most of the time to achieve The purpose of reducing fuel consumption. 