Smart split electromagnetic flowmeters are mainly used to measure the volume flow in conductive liquids and slurries in closed conduits. Including acid, alkali, salt and other corrosive liquids. The product is widely used in petroleum, chemical, metallurgy, textile, food, pharmaceutical, papermaking and other industries as well as environmental protection, municipal management, water conservancy construction and other fields.
Installation site requirements:
1. Split electromagnetic flowmeter placement Even though the ferromagnetic objects and equipment with strong electromagnetic fields are deployed (such as large motors, large transformers, etc.), magnetic fields and flow signals are not affected by the magnetic field.
2. The split electromagnetic flowmeter should be installed only to prevent the sun and rain, to prevent the situation temperature is higher than 60 °C and relative humidity is greater than 95%.
3. The placement of intelligent split electromagnetic flowmeter should be chosen so that it can be easily maintained and moved.
4. Split electromagnetic flowmeters should be installed on the back end of the pump and must not be placed on the suction side. Valves should be installed on the side of the mean flow.
5, split-type electromagnetic flowmeter should only be placed in a dry place, should not be placed in a wet, easy to place water.
Precautions
1. The sensor of the intelligent split electromagnetic flowmeter should be installed vertically and the fluid flows from bottom to top to meet the solid and liquid conditions in a mixed state. The reason is that if the medium contains solids (silt, pebble particles, etc.), precipitation may occur. In addition, fish and weeds in the pipeline cause the fish to swim in the pipeline, causing the output of the flowmeter to oscillate back and forth; the weaving back and forth of the weeds hung near the electrodes will also cause the output of the flowmeter to be unstable. A metal strainer is placed at the upstream entrance of the flowmeter to block fish and weeds from entering the measuring tube.
2. Split electromagnetic flowmeters that are used to prevent negative pressure from setting up properly will cause negative pressure in the sensor. When the flowmeter is closed at the same time, the downstream valve, if the fluid temperature is higher than the temperature. After cooling, it shrinks, creating a negative pressure in the pressure inside the tube. Negative pressure causes the lining to peel off from the metal conduit, causing the electrode to leak.
We manufacture high quality and good performance replacement EPE Filter Elements, which replace the original filter elements in size and function. Our Replacement Filter Element is installed in the hydraulic system to remove the wear metal powder and other mechanical impurity in the oil. Keep the oil clean to extend the life of the hydraulic system. They're widely used in Mechanical processing equipment, Railway internal combustion engine and generator, Automobile engines and construction machinery.
Epe Filter Element
Epe Filters,Epe Filter Element,Epe Oil Filter,Epe Filter Cross Reference
Xinxiang Tianrui Hydraulic Equipment CO.,LTD , https://www.filterelement.pl