What should you watch out for when using universal milling heads?

September 03, 2019

With the use of milling heads, the machining range and adaptability can be increased without changing the structure of the machine tool, so that some processes that are difficult to complete with traditional methods can be realized, and the workpieces can be repeatedly clamped and the machining accuracy and efficiency can be improved. Because the milling head expands the performance of the machine tool, it is equivalent to adding an axis to the machine tool, and even more practical than the fourth axis in the case that some large-sized workpieces are not easily turned over or the high precision is required.

Universal milling heads are now widely used in various fields such as aviation, automobiles, and molds. Mainly used in machining centers and portal milling machines, where light can be installed in the magazine and can be freely switched between the magazine and machine tool spindle. Medium and heavy duty have large rigidity and torque and can be applied to most of the processing requirements.

Universal milling head Note 1, the general use of non-contact milling heads oil seal, if the use of cooling water in the processing process, need to run before the water, and adjust the direction of the cooling water nozzle, so that water spray toward the tool, It can avoid the infiltration of cooling water into the body to prolong life.

2, to avoid prolonged processing at the highest speed operation.

3. Refer to the parameter characteristics of each type of milling head and use it under proper processing conditions.

4, before use, need to confirm the test run a few minutes heat engine. Each time you process, you must choose the appropriate speed and feed processing. The speed, feed, and depth of cut during machining should be adjusted progressively until maximum machining efficiency is achieved.

5, general standard milling head processing, need to avoid processing will produce dust, particles of material (such as: graphite, carbon, magnesium and other composite materials, etc.)

1. Introduction of Underground Oil Distillation Plant

Underground Oil Distillation Plant ,is the new technology which can refine the underground oil into base oil(which can be made into diesel and gasoline after processed by our catalyst) by vacuum pressure distillation system. The oil quality is better than the original normal pressure distillation technology, which show on purity ,transparence, lightness .this technology will do deodorization and destinke process to the raw material oil automatically by "dry type" vacuum pressure distillation method. With the vacuum distillation technology, the distillation temperature is considerably reduced, and the oil output will higher 5%-10% compared with original normal pressure distillation technology. It makes more profits to the enterprise virtually.

 

2. Raw material which can be used

    a. Waste oil .example: waste diesel, waste oil residue etc.

    b. tire/rubber oil

    c. plastic oil

    d. crude oil

e. waste engine oil

f. waste motor oil

g. waste lube oil

h. waste transformer oil

i. underground oil


3. Models of  underground oil distillation plant


 4. Installation: We will be in charge of arranging our engineer to go to your place to guide the installation and train your workers how to operate the underground oil distillation plant ,and buyer will be in charge of the food, accommodation and round air tickets.

 

 5.Underground Oil Distillation Plant Exporting Experience:

 America:

Brazil, Canada, Colombia, USA,

Middle East:

Dubai, Iran, Jordan, Saudi Arabia, Turkey

Europe:

Albania , Bosnia and Herzegovina

Asia:

Afghanistan, India, Malaysia, Pakistan, Philippines, South Korea, Vietnam, Myanmar

Africa:

Ghana, Mozambique, Zambia

 

Underground Oil Distillation Plant

Underground Oil Distillation Plant,Oil Distillation Equipment,Fuel Oil Refinery,Diesel Oil Recycling Distillation Plant

Shangqiu Sihai Energy Technology Co., Ltd , https://www.sihaienergy.com